bfifo - Byte limited First In, First Out queue
tc qdisc ... add pfifo [ limit packets ]
tc qdisc ... add bfifo [ limit bytes ]
The pfifo and bfifo qdiscs are unadorned First In, First Out queues.
They are the simplest queues possible and therefore have no overhead.
pfifo constrains the queue size as measured in packets. bfifo does so
as measured in bytes.
Like all non-default qdiscs, they maintain statistics. This might be a
reason to prefer pfifo or bfifo over the default.
A list of packets is maintained, when a packet is enqueued it gets
inserted at the tail of a list. When a packet needs to be sent out to
the network, it is taken from the head of the list.
If the list is too long, no further packets are allowed on. This is
called 'tail drop'.
limit Maximum queue size. Specified in bytes for bfifo, in packets for
pfifo. For pfifo, defaults to the interface txqueuelen, as spec-
ified with ifconfig(8) or ip(8). The range for this parameter
is [0, UINT32_MAX].
For bfifo, it defaults to the txqueuelen multiplied by the
interface MTU. The range for this parameter is [0, UINT32_MAX]
Note: The link layer header was considered when counting packets
The output of tc -s qdisc ls contains the limit, either in packets or
in bytes, and the number of bytes and packets actually sent. An unsent
and dropped packet only appears between braces and is not counted as
In this example, the queue length is 100 packets, 45894 bytes were sent
over 681 packets. No packets were dropped, and as the pfifo queue does
not slow down packets, there were also no overlimits:
# tc -s qdisc ls dev eth0
This manpage maintained by bert hubert <email@example.com>
iproute2 10 January 2002 PBFIFO(8)
Man Pages Copyright Respective Owners. Site Copyright (C) 1994 - 2018
All Rights Reserved.